[Jukebox-list] Wurlitzer 1800

[Chris K. Tanner]

Looking from behind the jukebox the run-off switch is mounted on the left 
hand side of the assembly, behind the tone arm mounting point. You will be 
able to see a micro switch that activates from a striker which is attached 
to the tone arm. The adjustind screw is behind the micro switch.
Chris.
----- Original Message ----- 
From: "Eric Anderton" <ercando at gmail.com>
To: <jukebox-list at lists.netlojix.com>
Sent: Thursday, August 03, 2006 2:46 AM
Subject: [Jukebox-list] Wurlitzer 1800


> Thank you to all who helped me solve my binding down issue on my 1800.
> The problem was the reversing switches were not engaging.
> Could I trouble anyone for the solution to two more problems?
>
> 1) When the selected record is done playing it is not ejecting. I have
> to reach in with my hand and lightly push the needle armature down to
> get it to eject.
> Where is the adjustment screw located for point of ejection?
>
> 2) When a coin is dropped in and the make selection light appears, the
> latch solenoid, located in the selector assembly no longer pulls the
> selection switches over. I tested the solenoid itself by swapping it
> with its twin in the coin grinder assembly, when I did this the coin
> grinder worked as it always had and again the latch solenoid failed.
> Do you think this could be caused by a bad latch solenoid resistor?
> Would you know what value resistor I could replace this with to find
> out?
> Many many thanks,
> It has been great just getting my beloved 1800 that I have owned for
> over 25 years just playing again in any capacity.
> Eric Anderton
> _______________________________________________
> Jukebox-list mailing list
> Jukebox-list at lists.netlojix.com
> http://lists.netlojix.com/mailman/listinfo/jukebox-list
>