[Jukebox-list] What value is the volume control used on an AMI'i'?

[Wesley Dean]

    You can isolate the control from the DC component (which causes the noise) by using a load resistor in the cathode circuit and coupling the signal through a .1 mfd.  If this this done, three wires must be used to the volume control. The shield as ground, the center tap used as the output of the control and the input to the high side. A 50 K log pot may be used. Wes
----- Original Message ----- 
From: "Juke of Shrewsbury" <jukeofshrewsbury at tiscali.co.uk>
To: "Jukebox mailing list" <jukebox-list at lists.netlojix.com>
Sent: Wednesday, August 09, 2006 3:02 AM
Subject: Re: [Jukebox-list] What value is the volume control used on an AMI'i'?


> Paul,
> It's actually a 35K pot, but used just as a variable resistor so a 47K would 
> be OK. If you are worried about audio noise when the pot is turned.... a new 
> pot may not make much difference! The design of the amp is such that moving 
> the pot always causes some noise on the audio.
> 
> Adrian.
> 
> ----- Original Message ----- 
> From: "Paul Taylor" <paul.taylor at georgestreetpress.co.uk>
> To: <jukebox-list at lists.netlojix.com>
> Sent: Tuesday, August 08, 2006 8:01 AM
> Subject: [Jukebox-list] What value is the volume control used on an AMI 'i'?
> 
> 
>> What value is the volume control used on an AMI model 'i' - also, is  it 
>> linear or logarithmic? Thanks for any responses.
>> _______________________________________________
>> Jukebox-list mailing list
>> Jukebox-list at lists.netlojix.com
>> http://lists.netlojix.com/mailman/listinfo/jukebox-list
>>
>>
>> -- 
>> No virus found in this incoming message.
>> Checked by AVG Free Edition.
>> Version: 7.1.394 / Virus Database: 268.10.7/409 - Release Date: 04/08/2006
>>
>> 
> _______________________________________________
> Jukebox-list mailing list
> Jukebox-list at lists.netlojix.com
> http://lists.netlojix.com/mailman/listinfo/jukebox-list