[Jukebox-list] How to remove Rockola 1448 PinBank

[dirksenj at bellsouth.net]

It will come out either way. I find that the pinbank gets 'cocked' a little, 
and binds up the shaft. Same for the pulley up front. I usually tap the 
shaft back in from the front just enough to remove the pulley, then tap it 
from the back and pull the shaft out the front. It's easier for me to pull 
the shaft that way while supporting the pinbank. Twisting while you pull 
helps, as does rocking the pinbank if it gets cocked.

Jim
----- Original Message ----- 
From: <wbabbott at cox.net>
To: "Jukebox mailing list" <jukebox-list at lists.netlojix.com>
Sent: Saturday, April 07, 2007 5:04 PM
Subject: Re: [Jukebox-list] How to remove Rockola 1448 PinBank


> Jim, forgot to mention I did loosen those two screps on the cog wheel of 
> the pop meter. Will that shaft come out the back as well as the front, 
> ie.. either directions? Also, it's a 1450 Playmaster, not 1452... my 
> mistake.
> Britt
> ---- dirksenj at bellsouth.net wrote:
>> There is a gear or pulley at the front of the mech for the pop meter (at
>> least on the 1448). You will have to remove two square head bolts holding
>> this to the shaft. Also, the allen screws in the back are pointed on the
>> inside end and fit into two grooves on the very end of the shaft - they 
>> are
>> longer than you think - and if you don't loosen them enough, they will 
>> dig
>> into the shaft as you remove it (unless you remove the shaft out the 
>> front).
>> Sometimes I do have to give the shaft a love tap.
>>
>> Jim
>> ----- Original Message ----- 
>> From: <wbabbott at cox.net>
>> To: <jukebox-list at lists.netlojix.com>
>> Sent: Saturday, April 07, 2007 4:25 PM
>> Subject: [Jukebox-list] How to remove Rockola 1448 PinBank
>>
>>
>> >I have a Rockola 1452 Hideaway in poor condition that I'm stripping for
>> >parts. This Hidewaway is basically the mechanism of a 1448 in a plain
>> >cabinet. I figured that stripping this down would give me a little more
>> >insight into the inner working of the 1448.
>> > My question is about how to remove the pinbank. So far, I have:
>> > 1. Removed the TT motor assembly and platform.
>> > 2. Removed the Contact Block holding the Cancel Relays
>> > 3. Took the back door off and loosened the two allen screws retaining 
>> > the
>> > shaft at the back record wheel.
>> > The shaft won't move, have I missed something or I wonder if the shaft 
>> > is
>> > frozen and needs some love taps from a hammer?
>> > Thanks for any replies in advance,
>> > Britt Abbott
>> > Chesapeake, VA
>> > _______________________________________________
>> > Jukebox-list mailing list
>> > Jukebox-list at lists.netlojix.com
>> > http://lists.netlojix.com/mailman/listinfo/jukebox-list
>> >
>>
>>
>> _______________________________________________
>> Jukebox-list mailing list
>> Jukebox-list at lists.netlojix.com
>> http://lists.netlojix.com/mailman/listinfo/jukebox-list
>
> _______________________________________________
> Jukebox-list mailing list
> Jukebox-list at lists.netlojix.com
> http://lists.netlojix.com/mailman/listinfo/jukebox-list
>