[Jukebox-list] Re: Seeburg record transfer fails on some slots

[Jay Hennigan]

Chad P. Hauris wrote:

> Thanks Ron...I pulled the mech out to the service position and it looks 
> like the safety plunger is not going into the magazine slot on the "bad" 
> slots...it is hitting the magazine separator. On the ones that will 
> play, like V8, the safety plunger is not in the center of the magazine 
> slot but at one edge. Also the tormat sliding contact on the front row 
> of tormat contact rivets is not resting in the center of the rivet but 
> at one edge...seems like this may be misadjusted? I could not see any 
> adjustment to get the contact finger toward the center of the rivet.
> None of the mech parts were removed from the mech shelf...I just removed 
> that whole assembly as one unit still attached to the shelf.
> --Chad

I think you mean the transfer arm, not the safety plunger.

Check the manual for the record rack and Tormat position adjustments and 
re-do them.  It sounds like the record rack is off-center just enough 
that the transfer arm hits the gap in some slots and misses on others. 
Also make sure that the clutch moves freely.

--
Jay Hennigan - CCIE #7880 - Network Engineering - jay at impulse.net
Impulse Internet Service  -  http://www.impulse.net/
Your local telephone and internet company - 805 884-6323 - WB6RDV