[Jukebox-list] Power & Control Wiring

[Ron Rich]

Peter,
  First off, when you post to this list, please start a new subject, rather then just changing the subject--it causes "bounce" problems if one responds, without realizing what you did, when there is lots of text in the message already--
  I don't quite understand your problem-If the switch assembly works OK in the "C", but fails in the "B", the problem lies in the WSR used in the "B". If, you are changing the WSR from phono to phono, and the service switch remains in the same cabinet, and fails in that cabinet, the problem is in the switch assembly--either an open connection at the plug-thru the wire-or at the switch itself, or, the switch is defective. In either case, you should be able to use a meter to discover where it's "open". Ron Rich 

Peter Davio <daviop at verizon.net> wrote:
  I'm still working on a Seeburg B. A small irritation - I can't get the
service switch to scan. It works fine in my Seeburg C and the power control
relay in the B works fine when I use the pin bank. What am I missing?

Peter Davio
-----Original Message-----
From: jukebox-list-bounces at lists.netlojix.com
[mailto:jukebox-list-bounces at lists.netlojix.com] On Behalf Of
jukebox-list-request at lists.netlojix.com
Sent: Tuesday, July 03, 2007 3:00 PM
To: jukebox-list at lists.netlojix.com
Subject: Jukebox-list Digest, Vol 48, Issue 3

Send Jukebox-list mailing list submissions to
jukebox-list at lists.netlojix.com


       
---------------------------------
Yahoo! oneSearch: Finally,  mobile search that gives answers, not web links.