[Jukebox-list] AMI G to Continental Record Cut Off Switch

[Nigel Pugh]

You don't need to modify the harness at all.
On the new switch, remove the 3 screws and there are 3 washer type things
behind them.
Discard these. Then screw in the original attachments directly. The new
screws are larger, but when you turn the screwdriver it will open up the
holes in the original attachments and they fit perfectly. No cutting /
soldering or modifying of the loom necessary.

Regards

Nigel

-----Original Message-----
From: jukebox-list-bounces at lists.netlojix.com
[mailto:jukebox-list-bounces at lists.netlojix.com] On Behalf Of Jay Hennigan
Sent: 23 May 2007 17:27
To: Jukebox mailing list
Subject: Re: [Jukebox-list] AMI G to Continental Record Cut Off Switch

Graeme Harvey wrote:
> I think yours may be the ones that have 3 large screws on the back if 
> this is the case the harness has to be modified.      I do not want to 
> modify the harness.      The ones I want have 3 small male pins.

Aren't the three male tabs attached to the switch with round-head brass 
screws?  I think you can transfer the tabs to the new switch.  Also 
depending on the nature of the failure you may be able to drill a tiny 
hole in the side of the old switch, give it a shot of CAIG De-Ox-It and 
get a few more years out of it.

--
Jay Hennigan - CCIE #7880 - Network Engineering - jay at impulse.net
Impulse Internet Service  -  http://www.impulse.net/
Your local telephone and internet company - 805 884-6323 - WB6RDV
_______________________________________________
Jukebox-list mailing list
Jukebox-list at lists.netlojix.com
http://lists.netlojix.com/mailman/listinfo/jukebox-list