[Jukebox-list] Wurly 2410 repeats same record

[Ron Rich]

Jackie,
  Smoke ainta no good---Is that motor an "open" or "closed" type? If there is an oil hole on it , oil it now.
  As for the cable attached to the brush--check that it is on the pulleys-not jamming behind one, and that the needle brush is adjusted so that the tip of the bristles just touches the tip of the needle as it passes by. Also, on some model Wurlys, the pivot point that the brush arm turns, on gets gummy-clean and oil it.
  Ron

etreble7 <etreble7 at verizon.net> wrote:
  Hi Jim,
many thanks, you were right on! It was the transfer switch. I am not sure 
why it's acting up, but I messed with the cable attached to the brush and 
manually moved the blade over so the spring would snap and then tried 
another record. It canceled out just fine.

I do however have another issue I noticed, the transfer is running very 
slow, the arm goes up very slow or comes down slow, then the record clamps 
and it runs up to speed. I also noticed a small amount of smoke coming from 
what seemed to be the motor up by the transfer switch before it started 
working again.Any idea what could cause that?

Also, Ron, thank you also for the reminder about the pawl. The one on the 
right (from the back of the machine) was all gummed up with oil. I'm 
puzzled as to how it got there because I cleaned those completely with 
alcohol not long ago and they were clicking, clean as a whistle. I wiped it 
off again, the one on the left seemed fine.

Everytime these Jukeboxes run, I am still amazed. I hope I never loose that 
thrill, it's just so much fun! Thank you all so much,
Jackie
----- Original Message ----- 
From: 
To: "Jukebox mailing list" 
Sent: Wednesday, September 05, 2007 7:09 PM
Subject: Re: [Jukebox-list] Wurly 2410 repeats same record


> If the pin is canceled, check the transfer switch - this is the "snap 
> acting" switch on the rear of the mech with the needle brush cable 
> attached. If it doesn't snap back at the end of the cycle, it will play 
> the same record over again. Make sure the mounting screws are tight before 
> turning the nylon-tipped adjusting screw. Good luck,
>
> Jim
> ----- Original Message ----- 
> From: "etreble7" 
> To: 
> Sent: Wednesday, September 05, 2007 1:42 PM
> Subject: [Jukebox-list] Wurly 2410 repeats same record
>
>
> Hi to everyone,
> I feel I've been blessed that this Wurlitzer has been working great, so I 
> haven't had to post a question for a long time. So here goes... the same 
> record is being repeated. The pin is canceled but then the song is over 
> it rejects, returns the record to the basket and then picks it up 
> again....over and over. If you make another selection, the correct pin is 
> pulled but the magazine doesnt move, it just repeats the same record.
>
> Thanks for any help, it's much appreciated.
> Jackie
> _______________________________________________
> Jukebox-list mailing list
> Jukebox-list at lists.netlojix.com
> http://lists.netlojix.com/mailman/listinfo/jukebox-list
>
>
> _______________________________________________
> Jukebox-list mailing list
> Jukebox-list at lists.netlojix.com
> http://lists.netlojix.com/mailman/listinfo/jukebox-list 

_______________________________________________
Jukebox-list mailing list
Jukebox-list at lists.netlojix.com
http://lists.netlojix.com/mailman/listinfo/jukebox-list


       
---------------------------------
Got a little couch potato? 
Check out fun summer activities for kids.