[Jukebox-list] V200 Tormat Contact Block Wiring

[Wesley Dean]

    Jim, if you ground the long plate in the center in the Tormat to the 
frame of unit you will not need the two contacts that ride on the long 
plate. Just be sure the new ground does not interfere with the moving 
parts. A small bare wire will do. Wes
----- Original Message ----- 
From: "James Nation" <nation500 at hotmail.com>
To: <jukebox-list at lists.netlojix.com>
Sent: Tuesday, September 18, 2007 3:30 PM
Subject: [Jukebox-list] V200 Tormat Contact Block Wiring



Getting close to putting the V200 back together but found a loose black wire 
on the tormat contact block.  It is one of the very thin wires that connect 
to a contact pin.  I have two different sets of schematics but....well I 
cant read them well enough to understand.  There are 4 contact pins, one 
with a red wire connected OK, one with orange connected OK.  One with a 
black connected OK to a larger black solder contact and the loose black wire 
connected to the pin but not to a solder contact.  Can i just get a 
confirmation that this connects to the same contact as the other thin black 
wire.  Thank you Jim
_________________________________________________________________
More photos; more messages; more whatever – Get MORE with Windows Live™ 
Hotmail®. NOW with 5GB storage.
http://imagine-windowslive.com/hotmail/?locale=en-us&ocid=TXT_TAGHM_migration_HM_mini_5G_0907_______________________________________________
Jukebox-list mailing list
Jukebox-list at lists.netlojix.com
http://lists.netlojix.com/mailman/listinfo/jukebox-list